What burn-in is
There are two effects, and they are often confused.
Image persistence is a faint ghost of the previous picture that fades after a few minutes of normal use. It is temporary.
Burn-in is a lasting mark. On an OLED screen every pixel makes its own light and dims slightly with use. Pixels that show the same bright image for a very long time age faster than their neighbours, and the difference becomes visible as a shadow of that image.
Apple describes both in its notes on iPhone OLED displays. It calls persistence temporary and says burn-in can happen in more extreme cases, when the same high-contrast image is shown at high brightness for prolonged periods.
Which screens are at risk
- OLED phones, tablets, monitors and televisions are the ones to think about.
- LCD screens, including most office monitors and older tablets, light the whole panel from behind. They can show temporary persistence, and lasting marks are much less common.
If you are not sure which you have, look up the model. As a rough guide, a screen where black looks completely black in a dark room is usually OLED.
What raises the risk
The same three things come up in every manufacturer's advice: a static image, high brightness and long hours. A clock at full brightness, in one spot, all day every day, combines all three. A dim clock for a few hours in the evening does not.
What this site does about it
- It moves. After ten minutes in full screen, the clock shifts a few pixels once a minute along a slow loop, so no pixel carries the same edge of a digit for hours. This is on by default; the setting is Burn-in protection.
- It dims. The Brightness slider in Settings lowers the digits to as little as 15 percent.
- It has a dark option. The black screen clock shows grey digits on true black, so most pixels are off.
What you can do
- Lower the device's own brightness. This helps more than anything else.
- Hide the seconds with S only if you prefer the look; changing digits are kinder to the screen than fixed ones, so seconds do no harm.
- Do not run the same clock on the same OLED screen around the clock for weeks. Alternate with other content or let the screen sleep overnight.
- Leave the manufacturer's protections on. Many OLED TVs and monitors run their own pixel shift and panel refresh routines.
- Change the look now and then. Switching between the flip clock and the analog clock moves the wear around.
The short answer
On an LCD, do not worry. On an OLED, a dim clock with burn-in protection on is a reasonable thing to run for hours at a time. A bright clock left in one place for months is how screens get marked.
Sources
Steps checked against the linked sources in November 2026. Menus change; if a step does not match your device, tell us.